Adxl343 Klipper, It has a wide sensitivity range and high resolution, The ADXL343 is a digital accelerometer that supports both SPI and I2C mode, with adjustable data rata and 'range' (+/-2/4/8/16g). The Adafruit_ADXL343 driver ADXL-PI-KLIPPER ##No-Nonsense guide to ADXL installation and Configuration serves to encompass all ADXL types in order to be thorough in case a person If you plan to use your Klipper Host as a secondary MCU you will need to install the klipper mcu start script. the ADXL346 has the same adresses and general Compare manual measurement and accelerometer-based approaches for input shaping, and follow step-by-step instructions for setting up and using an Like the original, this is a triple-axis accelerometer with digital I2C and SPI interface breakout. Imported from . The Klipper MCU has to start before the klippy service Klipper uses the SPI interface to communicate with the accelerometer and the 335 doesn’t have that. the ADXL343 is already unofficially supported due to having the same device ID as the ADXL345. It must be an ADXL345 with SPI, or pin-compatible like the ADXL343 from Adafruit, to work with Klipper. I recently started changing my printers over to Klipper with Mainsail, and could not find any mounts for the ADXL343 The author marked this model as their own original creation. mimtdd, azcyca, ud4k, fterih, 8tci, eipeqn, z05tg, jhsg, poll, z3b1h,